Aerogarden Labels
I bought a three pod Aerogarden a while back, and I’ve been experimenting with growing my own seeds in it. I came up with an Omnigraffle template for the labels to go on the top of the seed pods. It’s a double sided template where one side is a label for you to write on and the other side is a cutting template. You can run it through in duplex mode if you have a printer that supports that, but I’ve found that depending on the printer you can get better alignment by running it through the printer twice. Originally I had printed this on card stock, but in hindsight that was obviously a bad idea. It ended up waterlogged and started molding after about two weeks. I ended up ordering some Rite in the Rain waterproof paper which is supposed to be mold proof.
Here is a picture of the Rite in the Rain labels:
More photos: Flickr
I glue these on using rubber cement. I’m not 100% sure with that, because Download Template: PDF | Graffle
